Dezhou Minao Machinery Equipment Co., Ltd.

The new breeding heating equipment [fuel hot air blower] is energy-saving and environmentally friendly, with fully automatic temperature control. The contact hotline is synchronized with WeChat! Dezhou Minao Machinery Equipment Co., Ltd.! Please contact us for details
When using industrial heater equipment, you should pay attention to the following points. When the temperature in winter is below ℃, there will be a layer of ice and frost on the front windshield. Start the engine and when the water temperature rises above ℃, move the operation to the defrost position as marked on the signboard, put the cycle in the indoor circulation position, turn on the blower motor and put it in the third gear position. At this time, the motor speed is the highest, making it Work for minutes, and then move the gear to the first or second gear according to the defrosting situation. It is best for the driver not to leave the cab at this time. If the motor is found not to rotate, the motor gear should be returned to the closed position immediately to avoid burning out the variable speed resistor. When the outside temperature is low and there are many drivers and passengers in the cab, there will be frost on the glass. You can put the operation in the defrost position and the outdoor circulation position. The motor can be put in the first or second gear position, so that the frost can be removed. clean. When there is no sand and dust outside, the circulation can be placed outdoors to make the air in the cab fresh. If there is sand and dust or the weather is too cold, put the cycle indoors to prevent sand and dust from entering the cab.
After a period of operation, the heater water tank will have a layer of foreign matter and dust on the surface. If not removed, it will affect the heat dissipation. After the heater motor has been running for a long time, the motor should be maintained and replaced. This operation process must be judged and maintained by professionals. The motor cannot be disassembled without permission. This can easily cause a short circuit and the motor does not rotate. In the mild case, it may cause burns, and in serious cases, it may cause burnt wiring harness. ,on fire. The motor ventilation duct cannot be removed. If removed, the motor may overheat and burn out. The variable speed resistor can make the motor change gears. If the first or second gear is used for a long time, the resistor will easily burn out and affect normal use. If this problem is found, it should be replaced in time. After long-term use of the operating system, the operating cables are prone to aging and deformation, making the operation insensitive or inadequate. Do not move it rigidly to avoid damage to the parts. If you find this problem, you should go to the maintenance station for diagnosis, and repair and replacement should be carried out according to the specific situation. The ventilation duct is also the No. 1 hose of the heater. Due to long-term use in high temperature conditions, it is very easy to age and crack. If any problems are found, they should be replaced in time to avoid water leakage, excessive water temperature, and deformation of the engine cylinder head. Replace the hose with the hose supplied with the Xiali car. The defective hose is not corrosion-resistant.
Mobile phone number
Industrial fuel heater
///
Parameters
Model




Power




Voltage
︿
︿
︿
︿
Heat output< br/> /



Motor power




Output air
/< br/> /
/
/
Heating area
㎡
㎡
㎡
㎡
Fuel consumption
./
./


Mailbox capacity

Product size




Packing size




Net weight


Gross weight